Vega S17 · Powered by Color Prime
Vega S17
Your whole DTF line. One machine. One operator.
One person sends the file and walks away. It prints, cuts, powders, cures and stacks on its own.
Stacked and ready before anyone has to walk over. Lift the stacker out and it runs to the end of the roll.
Sealed in a cartridge and applied automatically. Nobody scoops it and there is no tray to shovel.
Or less, on the shop floor. Fully enclosed, three-stage filtration, no ventilation ducting to install.
Step 03 · Cut
Sheets that fit the press you own.
Trimmed inline in 0.8 seconds, at any length from 25 to 50 cm.
Step 04 · Powder
Powder loads like a cartridge.
Seat the cartridge, and that is the last time you touch powder. One cartridge runs one full roll.
0times an operator handles powder
Step 05 · Cure
The cure is already dialed in.
160 °Cheld automatically across all four zones, every sheet
Enclosure & footprint
It fits the shop you already have.
Fully enclosed, with three-stage filtration that captures fumes and fine adhesive powder. No ducting to install.
Control & support
It says what is wrong before you call.
Every job, temperature and error code is on the panel, and the machine reports its codes back to support.
Vega S17 · Powered by Color Prime · Engineered and built in Korea. Specifications are subject to change. Confirm current specifications with your dealer before ordering.